Agru Universal Coating Flamingo Synthetic Resin 1,000 kg 710 ml

descriptions

Agru Universal Coating for making plastic pipes UV resistant(PP, PVC-U, PVC-C, Agruair and Vinkair).

The coating reflects and absorbs UV radiation / sunlight, thus reducing thermal stresses, furthermore increasing the lifetime.

Technical Description

DESCRIPTION
AGRU COATING is a liquid synthetic resin paint for indoor and outdoor applications for plastic surfaces.
PHYSICAL PROPERTIES
Specific Gravity 1.41 g / cm3
Flash point 43 ° C (109.4 'F)
Boiling point: 140 ° C (284 'F)
Ignition temperature 225 ° C (437 'F)
Drying time, until you can touch the painting 1 hour
Drying time 6 hours
Colour Light gray (approximate RAL 7035)
Maximum time of storage 3-5 years (temperature > 10°C)
INFORMATION ON THE HANDLING OF THE PRODUCT
For the safe handling of the product AGRU asks and recommends to consider and observe the information of the Material Safety Data Sheet (MSDS).
APPLICATION TEMPERATURE
At least 10 ° C (50 'F)
CONSUMPTION
About 0.1 l / m2
About 1 l / 10m2
UNDERGROUND AND PREPARATION
The substrate (surface to be coated) must be clean, dry, dust –free and grease.
Sand and clean well bonded old paintwork thoroughly.
Poorly adhering existing coatings have to be completely removed.
Clean contaminated surfaces thoroughly mechanically.
The surface must be clean and dry, free of dirt, oil, grease or contaminants of any kind. 
Constructions which do not conform constructive wood protection are not suitable for permanent paints. 
Exposed wood in outdoor areas or damp rooms has to be prepared with blue-stain primer first.
Peeling (roughening) of the surface with sandpaper 120 is strictly recommended
PROCESSING GUIDELINES
BEFORE USE STIR THE COATING AS GOOD AS POSSIBLE!
The temperature of the paint object must be between + 10 ° C and + 25 ° C. 
Do not process (about 80%) with extremely high humidity (danger of drying delay, or loss of adhesion).
Processing is carried out by brushing, rolling or spraying, depending on the purpose there are one or two painting steps recommended.
For processing (painting) standard ÖNORM B 2230 is basically valid.
Respect the drying time between two coating processes.
AGRU COATING can be applied with a brush, roller or sprayer.
The paint can be done by using a soft brush, nap roller or spray system.
AGRU COATING has always to be applied to clean and dry surfaces.
DRYING
At a temperature of about 20 ° C and 55% (relative air humidity) the paint is dry after 60 minutes and tack-free after 4 hours.
AGRUCOATING can be painted over after approximately 6 hours with conventional synthetic enamel.
Weathering can affect drying.
The optimum final bonding to the surface is achieved after a few days!
CURE (DRY TIME)
It is necessary to ensure sufficient drying time, the paint has to be protected from bad weather conditions (rain,snow, hail, ..) . 
High air humidity and low temperatures increase drying time. 
The paint should not be applied at temperatures <10>CLEANING EQUIPMENT
Tools and equipment used for the painting can cleaned with a mild solvent such as mineral spirits or paint thinner.
UV RADIATION
The painting reflects and absorbs UV radiation / sunlight, thus reducing thermal stresses, furthermore increasing the lifetime.
OTHER IMPORTANT FACTS
DO NOT USE THE COATING IF RAIN OR FROST ARE FORECATED WITHIN 24 HOURS RAIN / FROST IS FORECAST!
The tank must be tightened after use.
AGRUC OATING cannot be diluted with water.
One painting is usually sufficient, in the case of a second painting, the curing time must be observed approximately 6 hours.
STORAGE
Frostproof storage is necessary!